I would try a rest first and see if you could play the game, then if it craps out as time goes by, you could measure the voltage and confirm the level. With the board installed you could let it pivot down so you can get to the plug. or at the power distribution board on the door, most of the functions are written on the board. first two wires are red(+5vdc) next is green (ground). Its close quarters to check the voltages at the power supply itself, I usually test them at CN-1, its the big plug on the right side rear of board. The white switch, left hand side lower front, the plunger can be pulled out, that would tell the machine that the front door is closed,(even though its not) then you could try the reset. the two switches below the bill acceptor, one is for getting into the test mode, the other is a reset.(bottom one) same as using the key switch. you can jumper across them if you want, or replace with a open momentary push button switch. I do not have keys available, or power supplies. To determine which machine you have SG-50 21 1/4 wide, SG-32 18 3/4 wide.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |